Document Information

Document Type: FAQ

Product(s): LEAP Conbox/CIP RC/PT Girder

Version(s): All

Original Author: Bentley Leap Bridge Technical Support Group – VM

QUESTION:  How is "FSupp1Ld" and "FSupp1Rd" points of interest are assigned in Conbox?

ANSWER:

The additional POIs are created based on the options : In Design Parameters --> Others --> Sections Near Supports and under this heading there are 2 options.

Dead loads are permanent type loads: adding a dead load in the Final case will direct CONBOX to apply the loading in the Final case . If the user unchecks then "FSupp1Ld/Rd" option gets excluded.

And the distances are set in Geometry TAB --> Layout button --> Bridge Component Layout --> “FaceofSupL(ft)” and “FaceofSupR (ft)”