Getting VBA rejected error when opening a file in OpenBridge Modeler

ISSUE:  Getting VBA rejected error when opening a file in OpenBridge Modeler with the following informational dialog:

SOLUTION:  This happens when some DLLs are not properly registered during OBD/OBM install.

Follow the steps shown below to resolve the issue:

• Exit OBM (and OBD) if you have any files open
• Open Command Prompt as an administrator:

• In the Command Prompt navigate to “C:\Program Files\Bentley\OpenBridge Designer CE 10.10\OpenBridgeModeler” folder and then run OpenBridgeModeler.exe /regserver
• If the issue is with standalone OpenBridge Modeler, then navigate to  “C:\Program Files\Bentley\OpenBridge Modeler CE 10.10\OpenBridgeModeler” folder and then run OpenBridgeModeler.exe /regserver

• Open OBM again and try to open the file again.