AECOsim SS5: "cut solids by curves" applied on architectural and structural objects. How to fix the final geometry?

Could you provide the workflow and settings in the tool in order to reproduce the issue in AECOsim Building Designer?

Hi Gerard and T_Wollet,

I send an image to explain it. This is a slab created with "Place floor slab" tool from Architectural tools.

We Cuted by solids to this slab, and we want to delete the "feature", because we only want the final geometry of this slab.

The only way to do it is using "Merge Feature list". But If we use this option, the slab is converted to Triforma Solid BREP, and then, we loose the slab Quantities (Top area, bottom area, etc.....)

Regards,

Xavier C.A.

EiPM

By the end, we need to avoid the "features" inside the bim objects.

Another example with slabs. If we need to join several slabs (maybe two, maybe hundreds of slabs), the final slab loses quantities. I attach two images to explain the "problem feature" with slabs:

Best regards,

Xavier C.A.

EiPM

For the first one, what is meant by "we only want the final geometry of this slab"? If you wanted to remove the feature you can use the Delete button in the Features tab.

For the second, the only workarounds I can suggest are to either A) Trace a new slab using the vertices of the existing slabs, or B) Perform a Boolean Unite, allowing the Slabs to be converted to SmartSolids, then use that resulting boundary to flood a new Slab.

I can see this too where you have an extremely large site (2500 acres) and in my case slabs all over the place.
I can redraw then but a combination (Merge solids would be great) it may have to be limited or take on only the active part.
I do note one issue would be if the solids are not fully co-planar or sloped.
I would able to be able to merge these even if stepped or sloped. And have an option to heal the joints on the underside where gaps occur merging sloped solids.
We are in 3d, after all and should not be limited so singular planes even in ABD.

I can see this too where you have an extremely large site (2500 acres) and in my case slabs all over the place.
I can redraw then but a combination (Merge solids would be great) it may have to be limited or take on only the active part.
I do note one issue would be if the solids are not fully co-planar or sloped.
I would able to be able to merge these even if stepped or sloped. And have an option to heal the joints on the underside where gaps occur merging sloped solids.
We are in 3d, after all and should not be limited so singular planes even in ABD.