Floor Selector reverts back to "None"

Hi Gary, try applying a Save Settings (File > Save Settings or CTRL-F). That appears to be working for me.

That does not appear to be working for me. I select a floor, Save settings, switch models (within the same file) and repeat. The floor select reverts back to None when I return to each previously set models.

I hope that is the the intended workflow...I would rather see each model retain the last floor selection regardless of doing a Save Settings.

That certainly is not normal behavior - a Save Settings should always retain the last active floor used by the DGN file. Have you noticed any other odd behaviors when it comes to design file settings; e.g., active Part, level, color, etc.?

I just tested on multiple models in the same .dgn file. It works for mine. If I do not apply a Save Settings in a model then ti reverts back to None.

As a test, I replaced my project BB_FloorMaster.dgnlib with a delivered one from the SS6 examples and Save Settings now appears to be saving the Floor Selector. I'm not sure why my project file was not working?
As I noted earlier, I hope Bentley provides an alternate way to having to run Save Settings to save the floor manager setting between models of the same file. I always have "Save Settings on Exit" set but this only runs when I exit the file.
Maybe add an "Save Settings on Model Close"? or introduce a config variable to address this?