floor manager

I am unclear on what the floor manager is supposed to do

I am told with Revit when MEP services are modelled they can be automatically annotated and dimensioned

Does the floor manager enable automatic labelling of duct/pipe levels and dimensions off grids?

If that is its purpose is there a guide or example avaliable

i have been working on a number of large projects using the Bentley mechanical software and they were all manually dimensioned and had  manually edited level cells

Parents
  • Hi David, just to get back to your original question...
    When you place mechanical components with a floor set active, the Base Offset value set in the place component tool settings will be relative to that floor. In common with other ABD tools the Base Offset is only used at placement and is not stored.
    Regarding auto-annotation the mechanical Drawing Rules can be modified/created to show a range of values: Top/Centre/Bottom of duct and Invert levels at start and stop of run for pipework. These are all measured from model zero, not from each floor as we do not store the initial placement Base Offset.

    Marc

  • But if the elevations of floor change and thus ACS changes - Do the mechanical units , stairs, other floors, ceilings, structure, - do they change ?

    Ustn since 1988
    SS4 - i7-3.45Ghz-16 Gb-250/1Tb/1Tb-Win8.1-64b

    Eric D. Milberger
    Architect + Master Planner + BIM

    Senior  Master Planner NASA - Marshall Space Flight Center

    The Milberger Architectural Group, llc

  • Yes they do in Revit.

    HTH

  • Hi Majang
    And the doors seem to have handles...
    Lots of thanks for the videos Majang. They are useful to compare and thinking....
    Regards
    Borja
  • You are very welcome. Bentley will never be able to introduce the quick changing of the floor heights that you can see in the video above. It is very funny that Bentley always compares AECOsim with Revit, as you can see AECOsim can't compete with Revit. Doing simple basic things is a nightmare and time consuming process.
  • Hi Mjang
    We remember someone told us that linking ABD elements to floor heights was a byzantine debate inside Bentley.
    Well, we think we must have this option from the beginning in ABD, later the user can choose use it or not depending on the project.
    We see you are fully convinced about Revit. We are still deciding wich software use as main platform. Your videos are useful to us to compare, assuming Revit has its own problems and things to fix.
    Regards
    Borja
Reply
  • Hi Mjang
    We remember someone told us that linking ABD elements to floor heights was a byzantine debate inside Bentley.
    Well, we think we must have this option from the beginning in ABD, later the user can choose use it or not depending on the project.
    We see you are fully convinced about Revit. We are still deciding wich software use as main platform. Your videos are useful to us to compare, assuming Revit has its own problems and things to fix.
    Regards
    Borja
Children
  • It has become a philosophical thing. If Bentley could just focus on making productive output for a while. When you are invested for 35 years a change is hard. But when you can no longer hire engineers that use the same software it makes you think.
    the Potential is better than Revit however we need a Rocky moment here.

    Ustn since 1988
    SS4 - i7-3.45Ghz-16 Gb-250/1Tb/1Tb-Win8.1-64b

    Eric D. Milberger
    Architect + Master Planner + BIM

    Senior  Master Planner NASA - Marshall Space Flight Center

    The Milberger Architectural Group, llc