2d drawings from 3d models in architectural practice with Microstation only

Has anyone used Microstation V8i for producing 2d drawings from 3d models in architectural practice -early design and working drawings?  Any advise where to start? Can anyone give me one to one tuition for a few hours? Please bear in mind that I am just an architect not very competent in IT.  But not too bad in building 3D models for presentations/design refinements.

  • This is really a question for the MicroStation Forum however, the tools you need to look at are the Callout creation tools in the Drawing Composition task.

    This topic on the LEARN Server will give you an introduction, look for the "Producing Project Deliverables-Creating and Printing Cut Sheet from Project Data" session.

    Regards

    Marc

  • Thank you Mark¬†
     
     
    I will contact you to discuss as soon as I can find a little breathing air from the pressures. 
     
     
     
     
    Regards
     
     
     
    Oktay Karel Diploma Architect RIBA
    for

    a plus d architects
    107A North View Road
    London
    N8 7LR


    020 8348 2692 or 07946 352 193
    Architecture+Design London Ltd \ Registered in England and Wales \ Co No 5463620
    CONFIDENTIALITY: This e-mail message (including attachments, if any) is confidential and is intended only for the addressee. Any unauthorised use or disclosure is strictly prohibited. Disclosure of this e-mail to anyone other than the intended addressee does not constitute waiver of privilege. If you have received this communication in error, please notify us immediately and delete this. Thank you for your co-operation. 
    The content or any attachment to this email may contain software viruses. While aplusd has taken reasonable precautions to minimize virus risk, it cannot accept liability for any damage which you suffer as a result of software viruses.