image repath read only, How do I get it readable?

RE: image repath read only, How do I get it readable?

Tathagata Saha — Fri, 14 Jun 2019 07:14:05 GMT

Good to know the issue has been resolved

RE: image repath read only, How do I get it readable?

Caddman13 — Thu, 13 Jun 2019 14:25:05 GMT

I found the problem. When this file was exported from Revit it created a second reference file that had all the images loaded into it. I had to open that reference file and repath the images and then they appeared correctly.

Thank you for the help.

RE: image repath read only, How do I get it readable?

Caddman13 — Wed, 12 Jun 2019 10:33:51 GMT

Tathagata,

I had update 4 and just installed 5. Same version of Revit to DGN conversion on same project. Version 5 I can't right click and get File Name to allow for a folder selection. It show read only.

Thanks

RE: image repath read only, How do I get it readable?

Tathagata Saha — Wed, 12 Jun 2019 07:14:33 GMT

Hi,

When you say that you were able to right click and select File Name earlier, in which version of OpenBuildings Designer were you able to do so? Also, in which version are you not being able to do the same now?

Besides, are both the scenarios occurring in DGNs coming from the same Revit version?