Just wondering if I can have a separate tool setting dialog for the stfplace commands (column, beams etc.) rather than as a ribbon? I have my ribbon in compact mode, I access to my required tools through toolbars. Everytime I place something that involve the Placement ribbon, I have to click on the ribbon to get to the settings.
We found a defect in the ribbon where it's not behaving correctly in compact mode. It should be switching to the contextual tab so you don't need to click on that tab manually. It's supposed to switch to that ribbon tab whenever you launch a command that uses it and return you to the previous tab when you reset.
As time goes on, I would expect to see more placement options in the ribbon, not in a separate dialog.
Can I submit a change request to have tool settings stays in structural property panel? I just can't understand why we need 3 different places for tool settings.
Can you please share the defect number? so that I can submit a SR to track it.
Also to clarify, the ribbon does switch to Placement ribbon, however, because it is in compact mode, I have to manually expand it to get to my settings. The fact that I have to refer to the ribbon for placement settings is already a massive time waster.
Hi Steve, SR 7000930459 was raised few days ago. Ribbon is fine, contextual or not, as we don't use it, unless forced to. But it would have been great if when forced to use ribbon, the thing worked properly, which it doesn't at the moment. I can't really see any productivity gain when you have to move your mouse full circle around your screen to place a column properly.
Would love access to the old Linear Members toolbox again :-)
With a bit of elbow grease, you can Bear. Most of the keyins I believe is still there. Just need to copy the toolbox over from SS6.
Was hoping to avoid doing so, but looks like I'll have to take the plunge.
Great, thank you. Just wanted to be sure it was official.