Trying to copy Fence contents is very slow in OBD comparing to v8i.
For example this attached file elements can be copied almost instantly using manipulate fence copy tool in v8i but takes 10minutes(yes minutes) in CONNECT.
Seriously? This is the reply I got to the service ticket. If I were end-user this answer would drive me crazy. 64-bit platform and we should accept it is slower than v8i. How this Update 5 even got to production if basic tools doesn't work.
I have gone through your file and I observed the hatch pattern (see the attached image) is made from single lines and when we use
manipulation tools it takes a lot of time in processing because application reads every individual line which slows down the process.
I have done testing compressing the file but the results were same- the process was slow.
Whereas in a new file the Fence manipulation tools are working smoothly.
So the manipulation process will be quick if you change small lines by using the hatch pattern.
The defect has been raised for this issue.
Thanks, at least this will be one of rare defects which will be definitely fixed. Please send me beta so could test it next time.
Still reported slow in Update 6. Trying to upgrade to Update 7 if not will have to revert user back to AECOsim again.
Oto, This is fixed in Update 7 for sure, please check once.
Answer Verified By: Oto
Yes seems to be fixed at least user no longer complains.