Frame Builder

Hello,
I would like to report several problems with Frame Builder in version AECOsim Connect update 4 up to Open Building designer update 6.

I have submitted several Service Tickets about this problem. It still is not resolved in the latest release. I find this very disappointing!

This software is NOT usable as long as these problems persist!

These problems did not occur in V8i.

1. When a window or door is placed as a shared cell in a linear form, it cuts a hole. When the window or door is adjusted the hole does not update.
2. When a window or door is placed as a normal cell, it is not possible to do a "stretch cell". This was possible in V8i.
3. When a window or door is placed as a shared or normal cell in a linear form it cuts a hole. When the cell is dropped, the hole does not remain, it disappears. In V8i the hole remained.

Thanks,
Wim