We have started the transition from CE03 to CE06 and have one workstation running CE06.
We typically set our BV clip volumes to CLIP ALL SIDES. They end up looking like this in an iso view, notice both the horizontal and vertical portions of the walls are clipped and resymbolized-- this is the view in CE03.
However the same file opened in CE06 is clipped , but only the primary cut plane is resymbolized. In the following view, notice that the vertical cuts are not resymbolized--inside the red loop
Is there now a setting that must be activated to resymbolize all clipped faces?
Please advise--
dmg
Hello Griffith,
Could you please try key-in "tfrebuild" and check again OR try to move the clip plane little bit and check again.
I would be also good to share the file.
Regards,
Aniruddh