Can you remove the fill of a wall in a section/wall

Hi,

I was curious if anybody knew of a way to make walls without fills in plans that are generated from 3d models. If you look at the example below, I have some walls which will be demolished, and I would like to keep the outlines visible. However, if you look at the image below, you see that the sinks (which are compound cells) are getting hidden. This in spite that the plane of the underside is under the compound cell.
Does anybody know any tricks to get this done? I hope I am just verlooking some settings.

Thanks in advance,

Jeroen

Parents
  • Hello Jeroen , 

    The walls are having cut patterns assigned to the walls. To remove the cut patterns you can go to Set Reference Presentation and then from there in the General tab, under the cut there is an option called Apply patterns. Unlick that and reload the ref, you will notice that the pattern is no more visible in the drawing, See the attached video forthe steps. I hope this helps you. 

      

    Regards,
    Alifur

Reply
  • Hello Jeroen , 

    The walls are having cut patterns assigned to the walls. To remove the cut patterns you can go to Set Reference Presentation and then from there in the General tab, under the cut there is an option called Apply patterns. Unlick that and reload the ref, you will notice that the pattern is no more visible in the drawing, See the attached video forthe steps. I hope this helps you. 

      

    Regards,
    Alifur

Children