dwg save like dgn

Is there a config var in CE to have dwgs to save directly to disk, instead of beeing interrupted every now and then.

Or not saving until you close (with alert to save/not save)

Parents
  • Hi Thomas,

    MS_DWGAUTOSAVE = <value in seconds>

    Determines the frequency, in seconds, of the auto-save timer for DWG and DXF format files. For example, if set to 300 (the default), an auto-save will occur approximately 5 minutes after the first change to the design. The minimum value is 30 seconds.

    MS_DWGAUTOSAVE_NODIALOG = 1

    DWG and DXF format files take far longer than V8 format design files to save. Therefore, by default OpenBuildings Designer displays a dialog box allowing the user to defer the auto-save operation.  If this configuration variable is set, this dialog box is skipped and auto-save occurs automatically.

    Regards

    Marc

Reply
  • Hi Thomas,

    MS_DWGAUTOSAVE = <value in seconds>

    Determines the frequency, in seconds, of the auto-save timer for DWG and DXF format files. For example, if set to 300 (the default), an auto-save will occur approximately 5 minutes after the first change to the design. The minimum value is 30 seconds.

    MS_DWGAUTOSAVE_NODIALOG = 1

    DWG and DXF format files take far longer than V8 format design files to save. Therefore, by default OpenBuildings Designer displays a dialog box allowing the user to defer the auto-save operation.  If this configuration variable is set, this dialog box is skipped and auto-save occurs automatically.

    Regards

    Marc

Children
No Data