Labels for Mechanical Rules

Hello,

I'm using a 'Mechanical rule' to display some information about the piping on a drawing in OBD Update 9. It works very well to display: Diameter, Slope and the pipe level at start and end.

Now I have a question about the formatting of these labels:

  • How can I change the pipe level so that it only displays the actual level (preferable in another unit than mm)? And not the second part?

  • Whatever settings I make to the "Below" or "Above" position it doesn't seem to reflect on the actual drawing:

For example the snapshot above has the diameter set to "Above" 100x text height and slope to "Below" 100x text height. Still they appear on the exact same spot.

This is an example of the settings of one of the attributes:

I presume the "Format" box which now displays '%VALUE%' is where I can setup how the bottom-of-pipe level is displayed? Please refer me to the wiki page / manual / ... where I can find more info about this.

Then a third question: It looks like when I change "Justification" for one of the attributes it changes for all of them. I'd like to align the "End" level with a 'Right middle' position so that it's always displayed within the pipe segment.

Thank you in advance for any help!