training BBMS

Re: training BBMS

Steve Cocchi — Thu, 23 Jul 2009 00:46:35 GMT

The combination of AccuDraw and locks (including sticky Z) is key to freely placing elements in 3D.

Re: training BBMS

JordanH — Thu, 16 Jul 2009 02:34:09 GMT

I use ~~ACS~~ [EDIT: ACCUDRAW] to control the vertical direction of the duct. If you are having difficulty with duct not going vertical like you think it should, make sure you have turned off your ACS Plan and ACS Snap Locks.

Thanks,

Jordan

Re: training BBMS

dwashock — Wed, 15 Jul 2009 23:56:21 GMT

Yes a little. I've had to rush through this. Two weeks ago was the first time I'd ever used this product. I just figured out if I changed the ACS I could get the duct to go vertically. Are you saying that I can do this without using the ACS? I'll go back and look through the Accudraw information.

Thanks again

Re: training BBMS

JordanH — Wed, 15 Jul 2009 23:44:56 GMT

Have you learned how to use AccuDraw yet?

Thanks,

Jordan

Re: training BBMS

dwashock — Wed, 15 Jul 2009 22:29:24 GMT

Thank you. I have been muddling through. Currently I'm trying to figure out how to get duct work to go in the Z direction. I've been navigating through BBMS all morning and I just can't figure that one out. Also if I try to connect to an elbow it wants to connect to the center of it instead of the end.

Re: training BBMS

JordanH — Wed, 15 Jul 2009 21:50:05 GMT

I would try the onDemand training for Microstation first, then I would move on to OnDemand Training for BBMS. Feel free to ask any questions on this board as well.

Thanks,

Jordan