• Re: BV, DV and detail of design

    Hi i have read your messages and allow me to ask a question (SS2 + Architecture). In V8 2004, i have use DEM and it was very long to calculta my 2d. we are going to use V8I SS2. we have remake our config. We have pb to make extraction with the DEM…
  • Urgent : Crossing from Triforma to V8I + ARCHITECTURE

  • Door swings etc. disappear after .DWG conversion

    Hi all, I've noticed after creating a floor plan layout and converting the .dgn file to .dwg., the door swing for all the doors disappeared and are not apart ofthe file. Any suggestion on what I might have missed in the conversion process ? Thanks…
  • URG : Problems crossing TRIFORMA to Bentley ARCHITECTURE

  • VBA Program to Turn On/Off the Triforma 3D Setup Lock

    It is just good practice to use the floor manager to set-up your elevation working points, and so in general there is no need to be able to turn the Triforma locks on/off (ATFENV_3DSetup and ACS). But there are times when it can be a problem and it is…
  • Drawing Extractions in DEM

    I have a problem with my cuts in DEM, the fill in my cuts is displaced with 2mm up and 1 mm to the left. This is only happening when I have the Transpose to XY Plane" box checked and its only occurring in the section cuts, the plane cuts is fine. But…