I have created different Project folders under my own Worksets. but after i run the 'Project A' calculation, I found that the XML files as well as all the associated reports were saved at the 'Output Folder>Results' of 'Project B'. Can i change the path? Thanks
Hi Brian,
Can you please share some screengrabs of the output files?
Also, please do let us know which version of OpenBuildings Designer you are using?
Regards,Sayan Acharyya
Hi Sayan,
I am using OpenBuildings Designer Connect Edition Update 10 Version 10.10.00.199.
I run the calculation of Project- 2370-25 and the output file didnt appear in this project folder (refer Figure A). On the other hand, after i searched around, the files are saved at the other folder (Figure B). kindly tell if more screenshoot could help or the its not clear.
Figure A
Figure B
Regards
Brian
hi
It points toward my project folder now @2370-25'. but i just checked that _USTN_OUT, ES_DIR_RESULTS, ES_DIR_RESULTS_STEADYSTATE are still pointing to another project folder 'ES-QUICKSTART'.
Regards,
Hello Brian,
Please open you @2370-25*.cfg file & check the _USTN_OUT variable. _USTN_OUT = $(_USTN_WORKSETROOT)Output/
It should be pointing like this.
If you are still unable to get to understand, then please raise an SR, we would need to conduct a meeting.
Regards,Alifur
hi Alifur,
is it mean i should change the New value to $(_USTN_WORKSETROOT)Output/
as it it still pointing to output folder in ES-Quickstart.
Thanks,
Yes, but as you are not able to see the configuration variable in configuration variables dialog hence you have to make the change in 2370-25*.cfg file.
Hi Alifur,
Oh i get it. i am wrong to opening 'Configuration Variable dialog' while loading the 2370-25*.dgn file. the output are now saved to the project output folder now. thanks a lot.
However I just checked the .cfg files of another training and the output is also directed to ES_Quickstart (refer to the below). I wonder should i amend it eveyrtime i start a new project. and is it because i start a new project which use ES_quickstart as the template.
Thanks
Yes, try uncomment that line as _ustn_out is already defined in the workset_xx.cfg files. No need to define the same variable twice.