Hi,
I am working on a project and need to change the u-values to produce revised SBEMs, however, when I am global changing/setting up roofs & ground floors the u-values are not updating in PartL as per my input.
Can you take a look at this project and advise?
Kind Regards
Jamie
Hi Jamie - is it the Criterion 2 numbers that are not updating or the information in the data reflection report?
If criterion 2, can you provide a screen shot of that section of the report?Regards,
Duncan Brown
Jamie - the U-values for Ground Floors are set during the Setup Ground Floors in Roofs/Floors. If you wish to change them, you should modify them in there and re-setup the Ground floor, or use Change Surface from CAD Input in a particular room. Modifying the fabric will not affect this.You should also be aware of this, which can adjust the UA value.Regards,
Hi Jamie - Did you click through to the link on my previous reply?Regards,