Room is too complex to construct

RE: Room is too complex to construct

Duncan Brown — Thu, 09 Aug 2018 14:03:36 GMT

Great. Thanks for letting us know.

Regards,

RE: Room is too complex to construct

Jonathan Olise — Thu, 09 Aug 2018 14:03:03 GMT

Duncan

Thank you very much, it is working now.

Best Regards

Jon Olise

RE: Room is too complex to construct

Duncan Brown — Thu, 09 Aug 2018 13:51:24 GMT

If you examine the image on the left, the software can't pathfind across these joints. They are considered to be breaks in the outline. The image on the right shows how the drawing should look to be automatically defined.

You can click on the image to enlarge it.

RE: Room is too complex to construct

Jonathan Olise — Thu, 09 Aug 2018 13:40:33 GMT

Apologies

I was referring to the room with the red circle. I have also attempted to define the room with the black circle with the same results.

Regards

Jon Olise

RE: Room is too complex to construct

Duncan Brown — Thu, 09 Aug 2018 13:32:12 GMT

I'm not sure which room you are talking about? Can you take a screen grab of the room and highlight it for me?

Thanks,

RE: Room is too complex to construct

Jonathan Olise — Thu, 09 Aug 2018 13:30:40 GMT

Hi Duncan

Many thanks for your response. As far as I can tell, the above room is completly sealed, but I an still getting the same message. I do not see how it is any different from the self contained rooms highlighted on the document you have linked. Are there other reasons for this error message, or is it deifinate that a gap exists somewhere?

RE: Room is too complex to construct

Duncan Brown — Thu, 09 Aug 2018 13:01:48 GMT

Hi Jonathan.

Room outlines should be completely enclosed - the software doesn't consider internal doors, and they should be omitted.

This document contains some information on defining rooms.

Regards