SHOW PUMP DUTY RESULT HWS

Hi, this refers to the Return pump. I would suspect that your system is flow only. If you instead size a Flow and Return system it will display these results.

HI SHANE 

THIS IS INFACT FLOW AND RETURN SYSTEM AS PICTURED BELOW. 

ALSO, TO AVOID ADDITIONAL OUTLET PRESSURE IN CIRCULATING PUMP I HAD FOLLOWED BELOW PROCESS, HOWEVER THE OUTLET PRESSURE ARE ADDED. 

communities.bentley.com/.../pipe-sizing---outlet-resistance-is-considered-in-circulating-pump-sizing

, 

PLEASE COULD THIS BE CLARIFIED. 

REGARDS 

GL

HI SHANE 

THIS IS INFACT FLOW AND RETURN SYSTEM AS PICTURED BELOW. 

ALSO, TO AVOID ADDITIONAL OUTLET PRESSURE IN CIRCULATING PUMP I HAD FOLLOWED BELOW PROCESS, HOWEVER THE OUTLET PRESSURE ARE ADDED. 

communities.bentley.com/.../pipe-sizing---outlet-resistance-is-considered-in-circulating-pump-sizing

, 

PLEASE COULD THIS BE CLARIFIED. 

REGARDS 

GL

Could you please upload the project folder to this link and I will take a look.

SHANE 

THANKS FOR  THE LINK BUT IT DOES NOT OPEN UP; IT MIGHT BE DUE TO INTERNAL SECURITY SYSTEM HERE AT MY END. IS THERE OTHER WAY TO SEND YOU THE FILE. 

I have checked the link and it is working fine here, you may need to consult your IT about your browser permissions.

SHANE 

I HAVE SENT A LINK WITH THE FILE. THE ABOVE DISCUSSED PROJECT IS UNDER HWS FOLDER. 

THANKS 

Hi, the zip file is 200 MB, is this correct? This is very large for just a Netsys project - they would usually only be a few KB. Could you please just upload the HWS folder?