HI
ALTHOUGH I HAVE SELECTED "SHOW PUMP DUTY RESULT" THE SOFTWARE DOES NOT DISPLAY IT. PLEASE COULD YOU CLARIFY WHY IS THIS
Hi, this refers to the Return pump. I would suspect that your system is flow only. If you instead size a Flow and Return system it will display these results.
Shane Regan | Principle Building Performance Support EngineerHevacomp to OpenBuildings - A complete guide for every user | Bentley Communities
HI SHANE
THIS IS INFACT FLOW AND RETURN SYSTEM AS PICTURED BELOW.
ALSO, TO AVOID ADDITIONAL OUTLET PRESSURE IN CIRCULATING PUMP I HAD FOLLOWED BELOW PROCESS, HOWEVER THE OUTLET PRESSURE ARE ADDED.
communities.bentley.com/.../pipe-sizing---outlet-resistance-is-considered-in-circulating-pump-sizing
,
PLEASE COULD THIS BE CLARIFIED.
REGARDS
GL
Could you please upload the project folder to this link and I will take a look.
SHANE
THANKS FOR THE LINK BUT IT DOES NOT OPEN UP; IT MIGHT BE DUE TO INTERNAL SECURITY SYSTEM HERE AT MY END. IS THERE OTHER WAY TO SEND YOU THE FILE.
I have checked the link and it is working fine here, you may need to consult your IT about your browser permissions.
I HAVE SENT A LINK WITH THE FILE. THE ABOVE DISCUSSED PROJECT IS UNDER HWS FOLDER.
THANKS
Hi, the zip file is 200 MB, is this correct? This is very large for just a Netsys project - they would usually only be a few KB. Could you please just upload the HWS folder?
THE LARGE SIZE OF THE FILE IS DUE TO DXF FILE.
Hi, thank you for uploading the smaller file. I have downloaded this and will contact you via a Service Request shortly.