I recently tried to design a supply ductwork system in netsys incorporating a ductwork plenum but keep receiving the no flow in system message. I have followed the instructions as detailed within the manual but to no avail. When viewed in isometric the ductwork is all joined apart from within the plenum box. Thank you
Hi Christopher,
It is difficult to determine for certain what the issue is without seeing the project, however I have recorded a quick example of the process that may assist you:
Shane Regan | Principle Building Performance Support EngineerHevacomp to OpenBuildings - A complete guide for every user | Bentley Communities
Hi Christopher, it is impossible for me to say exactly why this is happening without seeing the project in question, so if you would like me to take a look please upload the project folder to:
https://bentley.sharefile.com/r-r27f67acc3a94276a
Hi Christopher, I have been inspecting it here. Just to confirm, is the small section with outlets S17 and S18 the relevant part?