I have constructed my hevacomp model in the design database using the load calculation tab along with sizing all my mechanical pipe and duct systems using the pipe and duct sizer netsys tab.
I am wondering if it is possible to transfer all this data into the SYSTEM BUILDER "TOTAL BUILDING DESIGN " tab without having to re model and size all my work that I have already done.
any help on this matter is most welcomed
Seamus Murphy , BEng , BEng Ord
There is no way of doing so unfortunately, the programs use quite different formats so they are not interchangeable. Generally I would advise using Design Database and Netsys, as System Builder has not been updated for quite some time.
Shane Regan | Senior Building Performance Support Engineer
Thanks for your reply.
That's good advice cheers. I will continue going the way I was originally going using the design Data Base as well as the Netsys pipe and duct sizing tools.
No problem at all Shay, if you need anything else just get in touch.