Specifying ductwork size to conduct an analysis

RE: Specifying ductwork size to conduct an analysis

Shane Regan — Tue, 07 Dec 2021 15:56:16 GMT

Hi Duncan,

No worries at all, just thought I'd check! Netsys is much the same process, but a little more straight forward. Glad that helped sort it out for you in any case.

If you need anything else please just get in touch.

Regards,

Shane

RE: Specifying ductwork size to conduct an analysis

Duncan Carroll — Tue, 07 Dec 2021 15:48:43 GMT

Hi Shane,

Firstly I'm using System Builder because I've been told to. The joys of work!!

Secondly, Thank you very much for that answer, you've sorted me right out, because as I'm sure you can tell I'm not very experienced with Hevacomp.

Thanks,

Duncan

RE: Specifying ductwork size to conduct an analysis

Shane Regan — Tue, 07 Dec 2021 14:34:07 GMT

Hi Duncan,

Firstly- is there any particular reason you are using System Builder? This has been unsupported for quite some time. For duct and pipe sizing we would recommend using Netsys.

In relation to your query - yes you can indeed accomplish this, but it is via each duct rather than the System marker. To do so, select the below option, and then select the duct you wish to change:

Regards,

Shane