Hi John,
I thought of filling in here. This might happen because of improper installation, is this happening for a project or while opening the software?
Regards,
Krishnendu
Hi Krishnendu,
It occurs when I create a new project and attempt to import a dxf file at the start of the project. Run-time error 53 pops up a lot.
John
Krishnendu is correct - all these errors are basically for the same reason - a part of the installation is missing. When installed correctly your version should read:
CP3 corresponds to content pack 3 - this contains all content data for pipes etc, so Netsys will not work without this.
To resolve:
1. Go to Control Panel > Programs and Features
2. Check if the content pack is listed, ie:
3. If so, uninstall it.
4. Install the Content Pack (named hcomp26060400en_updt3.exe)
This should sort the issue for you.
Regards,Shane
Shane Regan | Principle Building Performance Support EngineerHevacomp to OpenBuildings - A complete guide for every user | Bentley Communities
That worked. Thanks lads. Much appreciated!
Good stuff! Glad to hear that did the trick.