• Hevacomp to openbuilding designer. Heating, gas, Hot and cold pipework design.

    As i understand. Bentley Hevacomp is being retired and replaced with openbuilding designer. I cannot find any training for openbuilding designer to do with plumbing systems. Only ductwork ventilation systems. I would like to know how to design a heating…

  • Copying CWS Outlets to HWS

    Is it possible to copy outlets between CWS and HWS in Netsys? This would save a lot of time. Thanks

  • RE: Same Loading Units Different Flowrates

    For other users who may experience the above - this issue was due to different pipe sizing standards at each outlet. Please find further details here.

  • RE: How to include Hot water cylinder in Netsys (CWS)

    Hi Jozef, The guidance here should assist with modelling this.

  • Same Loading Units Different Flowrates

    Hi I have created a HWS system consisting largely of en-suits of bedrooms. Each en-suite has a two number of basins and 1 shower nozzle. They are calculated using the same method (BS EN 6700), and have the same loading units. They branch coming in…

  • RE: de-active snap grid

    Hi Arun, you can change this setting by going to Pipes > Defaults, and deselecting the Snap Grid option. Also, if you wish to change the Ortho settings you can do so by going to Defaults>Ortho. You can see this operation if you view this document .
Communities
Support and Services
Training and Learning
Social Media