Topworks Angle

Hi Peter, 

Can you elaborate this issue ins some steps which you wanted to achieve?

Is this all about modifying the angle for topworks once placement is done? please clarify so that we could assist you in best possible ways. 

HTH,

When placing a :

• Wrench type operator, we are able to orient it during placement, both along pipe, and transverse to pipe.
• Gearbox operator we are able to rotate it along pipe, but not transverse to pipe.

Changing angle in modify component has no effect. 

TOPWORK_ANGLE is currently populated in Valve table of cat & Spec

Changing this value also has no effect

Image showing default placement of BV w Gearbox, default placement.

Rotating manually works, but is cumbersome if we have an Offset of Handle (OFFSET_X) set to other than 0.

Hi Peter, 

Thanks for the concern. I tested it and found it not working. But also in v8i this behaves same. 

Hence we would like to request to raise sr for this item to enable us to log enhancement to it. 

HTH,

done

Hi Rahul,

How about this question, I have the same issues about the TOPWORK_ANGLE，the HAND_WHEEL  just can adjust by 45°，

when i adjust the angle to 60° or other angle, the interface has no action, why? could you help me~