How to implement TOPWORK_ANGLE in AutoPlacement of topworks in OpenPlant Modeler CE?
Hi Peter,
Can you elaborate this issue ins some steps which you wanted to achieve?
Is this all about modifying the angle for topworks once placement is done? please clarify so that we could assist you in best possible ways.
HTH,
Regards,
Rahul Kumar
Product Engineer – Global Technical Support | Community Moderator
When placing a :
Changing angle in modify component has no effect.
TOPWORK_ANGLE is currently populated in Valve table of cat & Spec
Changing this value also has no effect
Image showing default placement of BV w Gearbox, default placement.
Rotating manually works, but is cumbersome if we have an Offset of Handle (OFFSET_X) set to other than 0.
Thanks for the concern. I tested it and found it not working. But also in v8i this behaves same.
Hence we would like to request to raise sr for this item to enable us to log enhancement to it.
done