Hi,
We have a requirement where we need to compute the area of intersection between two elements belonging to same layer. I tried Overlay in the Map Manager however it did not help. Would appreciate any help on this. I tried Create Region, Utility -> Data Cleanup, but non did work
Please refer attached image where area of circled area is required.
Thanks in advance,
Kiran.
Bentley Accredited Developer: iTwin Platform - AssociateLabyrinth Technology | dev.notes() | cad.point
Kiran Gulabrao Bandal said:Yes I used the Intersection mode since it has intersection option.
Great. I wrote "create region flood" and you use "intersection" instead of "flood". Frankly, why are you asking for help if you don't follow the advice afterward?
Kiran Gulabrao Bandal said:So, the flood option will help to achieve what I am trying to do?
Because not all requirements are known (it would be automatic or manual, what about element type of the result, its level etc.) it's hard to say. But I am quite sure it's the tool you should start with. And why you don't try it yourself, it's probably faster than to write your question?
With regards,
Jan
Dear Jan,
In my first post, I had listed the options I had tried, then only I turned to help. My statement was I had tried the tools on the toolbar you have mentioned, however, I could not perform selection for them to work.
I really am failing to see the reason for you giving me advice on whether should I ask for help on this forum or not or how much time it would take to try the options. If you do not want to help, that is fine.
Kiran Gulabrao Bandal said:I really am failing to see the reason for you giving me advice on whether should I ask for help on this forum or not or how much time it would take to try the options. If you do not want to help, that is fine.
Don't understand this sentence. So far there is not any proof from your side that you tried Create Region tool in Flood mode as recommended (and tested by myself, so there is pretty high probability it will work for you also). What you wrote and what is visible in your screen capture you tried something else: Create Region tool but not in Flood mode, because this mode does not require to select any element but to identify area by data point.
Regards,