Running Coordinates: Latitude and Longitude values format dd^mm'ss"

Question

I noticed that in BME SS4 08.11.09.862, using the Angle Readout tools in the Design File Settings to adjust the format and accuracy of the readout to dd^mm"ss.ss' (while the default is: dd.dddd^) does not work always. 
 Dan Weston's reply for the question below does not appear to work anymore! 
 https://communities.bentley.com/products/microstation/f/z_-archived-microstation-v8i-forum/66897/longitude-and-latitude-values-format-and-annotating-tool 
 Does anyone else in the community have this issue? 
 Tx 
 SRG

Komal Shinde · Accepted Answer

Hi, 
 We have found that in your DGN the selected ACS is LL84 while Geographic Coordinate System is UTM 84-44N. 
 We selected UTM 84-44N in ACS which helped us in getting Running Coordinates in the format dd^mm'ss" for your file. 
 Steps: 
 1) Open your DGN: Tools> Coordinate System> Auxilliary Coordinates> Select UTM 84-44N 
 2) In the lower-right section of the status bar, right-click the mouse and select Running Coordinates. Then Left-click the coordinate display on the status bar and select ACS Position. 
 3) Go to Settings > Design File > Angle Readout> Select angle readout as desired: dd^mm'ss" 
 4) Save the settings (File > Save Settings). 
 Let us know if this resolves the issue for you. 
 Thanks and Regards, 
 Komal S.

Sebastien Lefrancois · Answer

Hello! 
 I do not reproduce the issue. By saying " does not work always ", I assume here you have set the value and, when you come back in the file later, your setting is not there anymore. To keep any changes in Design File Settings (and for any settings), you have to use "Save Settings" function. 
 File > Save Settings Key-in: FILEDESIGN CTRL+F 
 I hope that helps. Sebastien Lefrancois