I work in an environment where my dgn files move from 2 different groups with different worksets. Every time when I use DGN file from other than my workset environment I get "WorkSet not found alert"
I know there is batch run key in commands available to set active workspace and workset but is there any way that I can apply my active WorkSpace/WorkSet without popoup message by autorun on 'opendesignfile' procedure. I tried some options nothing works out as this dialog box pops up way before open the design file.
Appreciate any help.
Thank you in advance.
Hello, I will suggest you to explore those two variables: MS_WORKSETMISMATCH_ALERT_EXCLUDE_VARS_WORKSPACELEVELMS_WORKSETMISMATCH_ALERT_EXCLUDE_VARS_ALLLEVELS For more details, see the page here: Uncategorized Configuration VariablesI hope that helps.
Sebastien
Thank you Sebastein for your suggestion. I set paths where my dgn files are located for not to workset compare but it did not work.
I still get alert message. I will keep exploring to resolve it.
ok. someone just told me it is only working by pointing to a variable not a path. I was not aware of that. Try this new scenario:MY_WS_MISMATCH = C:/Users/sebastien.lefrancois/Downloads/MY_WS_MISMATCH > C:/Users/sebastien.lefrancois/Documents/MyTemp/MS_WORKSETMISMATCH_ALERT_EXCLUDE_VARS_WORKSPACELEVEL > MY_WS_MISMATCH
Regards,
Thanks again Sebastien, this scenario did not work either. Not sure where workspace and workset information is stored in dgn file though to tackle.