GeoStudio | PLAXIS Forum How can I solve the following issue: 'Not enough load steps [102]' ?

How can I solve the following issue: 'Not enough load steps [102]' ?

Offline Sander Vanlanduyt over 3 years ago

Hi,

I am a masterstudent in Construction engineering and currently working on my thesis.

I am trying to make a Plaxis 2D model for a soilmix-element with a load-bearing capacity.
During the calculation I get the following comment: 'Not enough load steps [102]'

Is there anyone who can help me with solving this issue?

Thanks!

Top Replies

Offline Rushan Gizzatullin Thu, May 7 2020 2:49 PM +1

Dear Sander , According to 2D Reference manual, Appendix H, hint for error 102 is: Increase the value assigned to the Max steps parameter. We go to Phases settings window (double click on phase with…
Offline Rushan Gizzatullin Thu, May 7 2020 4:23 PM in reply to Sander Vanlanduyt +1

Dear Sander, If increasing steps does not help, I would check all geometry, soil and structures parameters, phase sequence. Also I would test some variants with different mesh coarsenesses. If it is…
Offline Sander Vanlanduyt Fri, May 8 2020 7:31 AM in reply to Rushan Gizzatullin +1

Dear Rushan, Ok. Thank you for the advice.