https://communities.bentley.com/products/geotech-analysis/f/forum/222606/parameter-variation---understanding-and-using-output-filesI have successfully run a sensitivity analysis and parameter variation, and now have access to the automatically generated output files corresponding to each case. Looking at the Reference Manual (p485-486) the following points gain my attention: en-USTelligent Community 12https://communities.bentley.com/thread/686452?ContentTypeID=1Thu, 09 Dec 2021 07:58:48 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:11748cf9-0cb4-404b-a93d-296de1121683Dennis Waterman<p>Dear Max,</p> <p>Projects 0 - 3 are the actually parameter variations, hence every of those projects represents a combination of parameters.</p> <p>The Min and Max projects gather for every node and stress point the maximum value that occurs in projects 0 - 3 and put that together. So the Min and Max project show for every point the minimum and maximum value over all variations. It can very well be that a certain node gets the maximum displacement from variation 1 and the minimum displacement from variation 2 while the adjacent node gets the maximum displacement from variation 3 and the minimum from variation 2 while the maximum excess pore pressure comes from variation 6 etc....</p> <p>This is what remark 1) in the manual indicates....</p> <p>With kind regards,</p> <p>Dennis Waterman</p><div style="clear:both;"></div>