Hello Everyone !
I try to validate FEM pullout test of single bar by comparing results with test data.
I have performed laboratory pullout test, as a result getting test curve - relation.Force - Displacement
I know internal friction angle of filling material and value of external pressure - in my opinion - this is
everything to compare results with predictions in PLAXIS 3D.
In Plaxis i have done a few models with different Rinter value.
I expected that some of FEM curves will be close to experimental ones
Unfortunately - the slopes of the FEM curves are the opposite that in experiment.
What could be the reason?
Regards!
Andrzej
Thank You Faseel Kahan
I have used your suggestion - service request.
Best regards !
Andrutt
The following paper may help you as it is a validation of pull out resistance of soil nails:Simulation of Soil Nail's Dynamic Pullout ResponseWithout the model it will be difficult to assess the reason for the behaviour that you observed. To assist you further please submit a service request. Then, one of our support engineers can help you in detail: https://apps.bentley.com/srmanager/ProductSupport
.