RE: Volume pile

Stefanos Papavasileiou — Thu, 13 Apr 2023 07:27:45 GMT

Dear Maha,

Please reach out to your administrator at your organization. It can be that your account is not correctly affiliated with your organization.

Your administrator can check this and reach out to support for solving this.

RE: Volume pile

maha alrudainy — Sat, 01 Apr 2023 17:54:25 GMT

Thanks for your reply

I am trying to contact: https://apps.bentley.com/srmanager/ProductSupport but I got this error :

Error TXH 1138,

Could you please help me to contact them.

Regards,

RE: Volume pile

Faseel Khan — Thu, 30 Mar 2023 11:37:24 GMT

Regarding the collapse error message there are some differences in the calculation procedure when a load is applied versus when a displacement is applied and that may be the reason for the collapse error. You may want to adjust the numerical control parameters for the loading case such as to reduce the load fraction per step and/or increase the unloading steps. To assist you further please submit a service request. Then, one of our support engineers can help you in detail: https://apps.bentley.com/srmanager/ProductSupport

The interface will have both material properties assigned to it and the assignment of the interface property will be based on which material the interface is facing.

As shown in the attached graphic three soil clusters are shown. When interface properties are selected as “From adjacent soil” then the negative interface on the left will have the parameters taken from the orange material. Similarly, the negative interface on the right will have the parameters taken from the green material. The positive interface in the middle will have the parameters taken from the yellow material and the interaction at this interface between these two nodes consists of two elastic perfectly plastic springs.