I have an unwrapped televiewer and 3D core image logs from WellCAD that I would like to import into a gINT log at the proper scale so the depths match. How do I do this? I've tried using bitmap symbols but they add black lines to the top and bottom of the image throwing off the depth and they are also discreet images that plot on a single page rather than log data that scales to depth.
The issue with the black lines is related to a single build of gINT that had an issue with bitmap symbols. It was 8.30.03.77. You will need a later version of gINT installed.
The technique for showing images at depth requires multiple pieces.
1. In INPUT setup a point id depth table with Depth (field type double), Bottom (field type double), Image field (field type bitmap)
2. In REPORT DESIGN Setup a bitmap symbol vs depth body entity
It needs to have the depth field match the table you created, the bottom field match the field you created, and the image field referenced in a project symbol function ( see example below)
INPUT
REPORT DESIGN
A photo log report can be downloaded from here as an example of this
http://communities.bentley.com/products/geotechnical1/w/wiki/3958.general-purpose-log-reports
Answer Verified By: Andrew Little
Mirrored bitmap image?
The above routine works fine with the exception that the image is mirrored left to right.
Any ideas?
Thank you
Roger
Panic over! My own fault - I have just rechecked the source file and found this to be flipped.
Im interested in this too, but cant seem to build the bitmap symbol vs depth in my report design. Any instructions would help.