Hi,
I have a report design (log) where I want to show the entire depth of the hole on one page, there are multiple holes with varying depths that will use this design.
Currently to do this, I went to LOG REPORT PROPERTIES>Report Structure>Depth Units Page 1 and left it blank.
This fits it all on one page but I have text under the last boundary line that shows up in some white space near the bottom of the page (TEXT VS DEPTH PROPERTIES>Boundary Text>Text Below Last Line) and then some general comments (TEXT VS DEPTH PROPERTIES>Main>Text Expression) that are being split and some of it pushed to a second page. The general comments has the Depth Expression set to the hole depth.
Is there a way to make the white space at the bottom larger to fit both sections of text? Or how do I control the position of the last boundary line?
I have included a screen shot that shows the white space (at the bottom) where the text needs to go.
Thanks.
In your input Borehole table, if you have a column for Depth log per page, you can set the depth of each borehole with a few extra depending on the the total borehole depth. This way each can have their own desired depth per page. If you get to do this, you should have the LOG REPORT PROPERTIES>Report Structure>Depth Units Page 1 to show the User system data expression of <<User System Data.Depth Log Page>>. (This user system data expression is in the standard gINT US or std gINT US lab library, under Report Structure tab of any report template).
See the example of the Input Borehole table: I am using the std us lab.gpj and std us lab.glb
Thanks for your response Aparna,
I think that is the right idea but I was hoping to have a report design that I could use for holes of varying depth and length of comments.
So far I have changed LOG REPORT PROPERTIES>Report Structure>Depth Units Page 1 to <<calc(<<point.holedepth>>*1.4)>> as that seemed like it gave enough white space for the logs with the most comments but the ones without a lot of comments look a bit off with the extra white space.
Would it be possible to make a formula that in some way counts the number of lines in the comments field and chooses the multiplication factor based on that?
Marshall,
In order for you to have more space at the bottom for the notes, you may want to try and not leave the LOG REPORT PROPERTIES>Report Structure>Depth Units Page 1 blank but add some more to the total depth of the hole.
For example below the Borehole has the total depth of 45 feet, and by setting it to 52 feet in OG REPORT PROPERTIES>Report Structure>Depth Units Page 1, it shows the following: