Hello,
Anyone knows how to enter a refusal value in the boring logs in GINT?. I used an old GINT version about 12 years ago and I am sure I was able to enter refusal expressions such as 50/2" or 50/6".
I noticed that my existing GINT version (10.02.00.04) is not allowing me to enter such expression. Does anyone know how to do this?. Refer to the file attached.
PDF
This would depend on how your report is set up. Some reports are setup to automatically report the refusal condition based on the length of the sample. Thus for your example change your sample length for sample 20 to 3" and see if the report shows what you want. If not, there are 2 approaches.
1. change the field type tp text to allow input of a non numeric entry. This may screw up other aspects of your reports and other reports that assume this entry for blow count will be numeric.
2. Modify your report so it prints the desired refusal using the input sample length and blow counts to assemble the refusal string
Thanks szang,
I tried your approach 1, however, the Field type i have by default is "integer" and doesn't let me change it. I tried checking the boxes on the right side of the window but the "type" box never got enabled.
Thanks szang
szang, could you please review this question?
sorry the table list shortcut is [ctrl] F8
Thanks szang. I think you missed a question that i asked earlier. I am going to ask it again, to avoid confusions:
Now i have another one: Refer to the file attached. I noticed GINT is trying to provide N values throughout the depth of the hole, including SS (split spoon) and AG (auger) depths. At the auger intervals, I did not record any blowcounts, therefore GINT is printing a dashed line.
Please start another thread for this question and I will respond. It is getting too confusing to navigate.