Log Report - Smoothing Data

Hi there, 

I am using the Datgel CPT Tool gINT Add-In to create CPT reports. During sampling some depth intervals were missed (eg. measurements jump from 1.55 m to 1.75 m). This is causing gaps in the reports where data was not measured. Is there a way that I can smooth over this data so that there are no gaps in my report?

Many thanks in advance. 

Parents
  • Hi Liadh

    The gap between readings that will trigger the line not to show is defined here: <<User System Data.DG CPT Plot Max Depth Gap>>

    To edit it, select DATA DESIGN | User System Data | DG CPT Plot Max Depth Gap

    You will get a straight line between points. I don't think having a longer straight line than the existing expression provides for, e.g. 50 mm, is going to look right.  I think it is fine to have gaps in your data if that is the reality.

    regards

    Phil

    Phil Wade
    Datgel
    Bentley Channel Partner and Developer Partner
    E: phil.wade@datgel.com | T: +61 2 8202 8600 & +65 6631 9780

    Get the most out of gINT with Datgel Tools.

Reply
  • Hi Liadh

    The gap between readings that will trigger the line not to show is defined here: <<User System Data.DG CPT Plot Max Depth Gap>>

    To edit it, select DATA DESIGN | User System Data | DG CPT Plot Max Depth Gap

    You will get a straight line between points. I don't think having a longer straight line than the existing expression provides for, e.g. 50 mm, is going to look right.  I think it is fine to have gaps in your data if that is the reality.

    regards

    Phil

    Phil Wade
    Datgel
    Bentley Channel Partner and Developer Partner
    E: phil.wade@datgel.com | T: +61 2 8202 8600 & +65 6631 9780

    Get the most out of gINT with Datgel Tools.

Children
No Data