How does one use the new functionality in the HoleBASE Template Studio for Follow-On Mode? I have been attempting to create a borehole log where the header is reduced on following pages. However, when I reduce the size of the header in the Template Setup it causes the logs scaling to become unreadable. It reduces the log to a single page that only has a maximum of 7ft of subsurface data on it. However, if I do not reduce the header size there is no issue but defeats the purpose of the follow-on mode.
In short, how do I effectively use the follow-on mode to reduce header size on pages following the first.
Thanks
Hi Jacob,
Thanks for asking about this, can you raise it as an SR with logs, config pack and data attached. We can then review it.
Martyn