I have two angled boreholes at 70 degrees, one with a orientation of 270 and the other 90. I have added the information into the Orientation & Inclination tab, this data appiars in the BH log as numbers, but it doesn't change the angle of the stick logs in the cross-section viewer and the the reduced level maod for the geological horizons are just the downhole depths minus the ground level, not the true vertical level.
Being fixed in Service request.
Is there any update on this? I'm really surprised (disappointed) that angled / inclined holes cant be presented on Openground cross sections
I haven't got this sorted yet, I have been out alot over the summer. I will pick this back up with openground over the winter to try and get this working.
any update to this? we are having problems with inclined borings as well. They do show up at an angle in the profile, but pointing in the wrong direction. Has anyone else seen or resolved this issue?
Not sure if we had the same problem as you, but we found that the Civil3D extension fails to project angled borings on a curved alignment. This may be an edge case since our alignment is 270 degrees of a circle, but it was showing angled borings backwards.
Our solution was to break the alignment into many short straight sections. Not an ideal solution, but it worked for us.