This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Pipe Slope with the round number for slope

Hi

I modeled a storm pipe network, everything is fine but my manager likes to see the slope as the round number like: 1%,  1.5 % , 2% ...

is there any method to force the software to change with 0.5% interval?

in this case if cover is a little bit higher than the min cover, that's fine for them but they like to have the slope as round number.

Please don't advice me to change those one by one in Design alternative.

 

Thanks

 

Hamid