• State Verified Answer
  • Locked Locked
  • Replies 3 replies
  • Subscribers 83 subscribers
  • Views 2281 views
  • Users 0 members are here
Captured to Using the zero diameter option in Darwin Designer wiki page
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Darwin Designer

dang tran.
Offline

Hi,

I am practicing Darwin Designer, in Cost/ Properties Tab, I see two type new pipe that  one's cost optional Pipes and onother is Cost new. I don't know meaning of the line that content zero value for both Diameter and Unit Cost. I also can't understand how to self-explain the some of results is zero as well.

Please explain for me..

Thanks!

 

Parents
  • 0 Offline
    Dang,

    Including a zero diameter entry in the costs/properties table gives Designer the freedom to essentially remove a pipe as a possible option in the design. This is demonstrated in the Quick Start Lesson called "Darwin Designer to Optimize a Pipe Network", under Help > WaterGEMS Help > Contents > Quick Start Lessons. This is also mentioned in the Help topic called "Costs/Properties Tab"


    Regards,

    Jesse Dringoli
    Technical Support Manager, OpenFlows
    Bentley Communities Site Administrator
    Bentley Systems, Inc.

    Answer Verified By: dang tran. 

Reply
  • 0 Offline
    Dang,

    Including a zero diameter entry in the costs/properties table gives Designer the freedom to essentially remove a pipe as a possible option in the design. This is demonstrated in the Quick Start Lesson called "Darwin Designer to Optimize a Pipe Network", under Help > WaterGEMS Help > Contents > Quick Start Lessons. This is also mentioned in the Help topic called "Costs/Properties Tab"


    Regards,

    Jesse Dringoli
    Technical Support Manager, OpenFlows
    Bentley Communities Site Administrator
    Bentley Systems, Inc.

    Answer Verified By: dang tran. 

Children
Communities
Support and Services
Training and Learning
Social Media