Hey Everyone!
I am currently trying to design a storage pond in Pondpack V10, and am running into a couple of problems.
First, the output generated by the model and displayed in the "outlet design" tab of the pondmaker worksheet is very different from the output generated by running a full routing of the flows. Specifically, the estimated storage is much lower than the actual storage required, and the interpolated flows of my outlet are much lower than the peak outflows generated by the model. This is making sizing my pond very difficult.
Also, I was wondering if there is any way to change options on the maximum water elevation (in the routing analysis tab) to display more than 1 significant figure. Right now, working in SI units, the maximum water elevation is displayed to the nearest 10 cm, which seems very high. As a result, I have a 50-year storm at an elevation of 60.0 m which passes the freeboard requirement (0.3m) and a 100-year storm at an elevation of 60.0 m (same elevation!) which fails. I'm guessing this is a rounding issue, but would like to know of a way to resolve the problem.
Thanks in advance!
Jeff