Hi,
I'm using Scada element in Sewergems to compare my results with field data. Unfurtunately when I graph all my Scada element only 24h is shown but the calculation options are set to 48h. I'm using SWMM solver and end date\ end time for duration type . I looked at the data in the graphs and there is 48h data (see below).
Do you know why ?
Thank you
Marie-Joelle
Take a look at the FAQ at the bottom of the following article titled "I can see the graph in SCADA Signal Editor but not in the Graphs, how can fix?".
SCADAConnect in SewerGEMS
Regards,
Craig Calvin
Bentley Technical Support
Jesse DringoliTechnical Support Manager, OpenFlowsBentley Communities Site AdministratorBentley Systems, Inc.
Hello,
2 years ago to solve this problem, I had to use SewerGEMS 32 bits version and Excel 1997 version as historic file Scada Element. I’m now using Sewergems (CONNECT Edition) 64 bits and Excel 2010, and I have the same problem : when I graph a Scada element only 24h of the historical data is shown but the entire simulation results are shown (48h). I’ve checked the dates, start/end simulation time.
Do you know why ? Is there a way to solve this problem ?
Thanks !
Hello Marie,
If that time you could solve the problem by using 32-bit of SewerGEMS, then you may try using 32-bit SewerGEMS Connect Edition to see if that works, which i suspect you already did.
We would need the model files and excel file you are importing through SCADA for testing purpose and to help you with the issue.
Sharing model files
Sushma Choure
Bentley Technical Suppport
Hello Sushma,
I'll try on the 32 bits version as you suggested. I've up loaded my model files (Bentley.zip).
I could reproduce the issue that you mentioned historic data is not visible half of the time in graph of SCADA signal element, though date and signal information is correct. Will update further on the progress as i work on it.
If I am selecting any other time like 24 hours, in calculation options then graph is seen properly, problem is seen for 48 hours.