This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Scada signal relative speed factor

Hi, Guys!

It is extremely convenient to have the option to define the units for a database source:

I can see that relative valve closure is present, and I can choose % or decimal.

Unfortunately the same does not work with variable speed pumps' relative speed factor, although I can match SCADA signals to a pump's relative speed factor, and generate control overrides based on that. My source data is in % instead of decimal values.

I couldn't edit the unit of relative speed factor in the units section. 

Is there a workaround for this, which I missed? (An obvious solution would be to alter the values in excel, or elsewhere out of watercad, but I tried to handle it in place, without altering my source data)

Best regards,