I use the Explicit SWMM solver dynamic wave as a solver in SewerGems to model two pumps in parallel. But I see that the solver doesn't account for losses and uses only the last point of the pump curve. My question is to know if is it possible that the solver takes into account the curve of the pumps as input (taken into account the pressure drops) and is not limited only to the last point of the curve?
The pump operation follows the pump curve setup in the pump definition. How are the parallel pumps set up? Pumps in parallel should have the same curve so as to work in parallel. What pump definition are you using?
If you can share a snapshot of how you have set up your pumps in parallel it would help us understand the operation.
Hope this helps.
Bentley Technical Support
I use the pump definition type : multiple point (type 3). The two pumps don't have the same starting and stopping levels. Here are the parameters of each pumps. They don't have the same pump curve.
I share my model "Farmer.zip" as confidential files for more informations.
I took a look at the model you uploaded and here are some of my observations and recommendations.
Try making the changes listed above and then compute the model again. If you are still seeing unexpected results, please upload an updated model and elaborate on what the current issue is (ie. what you are seeing and what you expect to see). It would also help if you would provide scenario you are looking at, relevant screenshots and steps to reproduce.
As Jesse mentioned, the pumps should operate based on the system conditions.
I share my model "Farmer.zip" as confidential files. Here, my first concern is with the PMP-1 and PMP-2 pumps. There is no water in the wet wells and the pumps do not output any flow which. This is normal. But a look towards the pipes after the pressure pipe shows that there is a flow equal to the maximum capacity of each pumps. I would like to know how I can fix this problem?
My second problem is with the PMP-4, after the cross-section PJ-4, the pipe has negative flow why? Is there a way to reduce these imperfections?
Your pump PMP-2 is set to "On" but in reality, there is no inflow to the downstream wet-well (PosPom-005) i.e. there is no flow accumulating in the wet-well for the pump to activate and pump flow downstream. From your response to Craig, I think this is expected in your model. Am I right?
However, since the pump status is "On", I think this unaccounted (additional) flow might be considered. Here is a reference article for this;
Unaccounted for flow in SewerGEMS
You can try the options provided in the above article and check the results.
When the pump status is set to "Off" though, these results are not seen i.e. no initial spike in flow in downstream conduit.
For the negative flow at PJ-4, I can suggest using a slightly larger output time-step ("SWMM Output Increment" under Calculation Options). This can give you betterr results.
Hope this helps.
Answer Verified By: Sushma Choure
Indeed, in my model, I do not expect water in the wet well for this scenario. I would wait to see my results when there will be more water.
Thank you team for help.