I moved up to using WaterGEMS V8i 10.01.01.04 a while back. Ever since then the pipes that I add junctions to have parentheses with a number following the actual label, P-20 (1). If it gets split again I get another set of parentheses, etc. Is there a way to turn this off?
Hello Jacob,
There isn't a way to specify how pipes are labeled after a pipe is split. The new labeling convention was introduced with WaterGEMS version 10.01.00.72. I have submitted a request on your behalf to be able to control how pipes are labeled after they are split (reference # 942272).
Regards,
Craig Calvin
Bentley Technical Support
Answer Verified By: Jacob Reigelsberger
I also documented this in the following article.
How to control the labeling method used when splitting pipes