Need help working from home with your Bentley software? We're here to help - click here
Can anyone please explain about these two different errors as shown in the screen capture.
I also insert some fake catch basins with percent capture 0.001 to start my gutter somewhere like GU16, GU 17 etc.
Are you saying the the flow results at the outfall are zero? Have you tried graphing the results to confirm if there is flow at other time steps?
The graph I mentioned can be ignored, since this is StormCAD.
I took a look at your model and this appears to be working as expected. The flow report at the outfall is flow related to channels or conduits. The gutter flow is still reported in the property field "Lost Surface Rational Flow".
I just wanna my model setup is good or not. Because I am getting high spread. I can only use up to 9.5 ft. When I used flow master with same data the spread is different and too low.If this model is working i will go for further design new sections.
Also, Once I rum automated design can I adjust the value manually? After adjusting I have to just analyse the network or I have re-run the design? I have four constraints velocity, cover, slope and spread, Is there any way to assign it in correct order because after assigning all constraints and set design inverts and pipe it gave random pipe slope to adjust constraints after design. I went through that guide "how to apply constraints " but it is still not working.
Please suggest me for my user notifications in my model, that is ok or still I have to correct it?