Hello everyone,
I tried to saw my profile by inserting terrain file but I didn't understand why the program is forcefully inserting ground elevation at rim. I ave this problem in most of the profiles plot. Please find the following attachment.
Thank you,
Hello,
1) Do you have "True" select for the node property "Update ground elevation from terrain model?"
2) If "yes" to #1, does it help if you move the node location very slightly? (which should trigger it to update the ground elevation)
3) What product and version are you using? (check under File > Help > About, or Help > About for older versions)
4) What type of terrain model are you using? (Bentley DTM? LandXML? Etc.)
Regards,
Jesse DringoliTechnical Support Manager, OpenFlowsBentley Communities Site AdministratorBentley Systems, Inc.
Yes, when I slightly moved node it changed the elevation after Design and analysis run.I am using LandXML. But the ground profile showing abruptly changed at rim as in the previous figure.
To update the ground elevation do I need to draw the inlets and pipes over scaled background layers otherwise how it will update the ground elevations at the particular place.I used schematic network.
Hello Hari,
Yes, models are backward compatible (models can be opened in a newer version of the software). However, they are not forward compatible (for most cases they can't be opened in a version that is older than was last used to save the model).
See: Model backward / forward compatibility
Edit:
Forward compatibility refers to the ability to open something that is saved in a newer (forward) version.
Backward compatibility refers to the ability to open something that is saved in a earlier (backward) version.
Craig Calvin
Bentley Technical Support
Can you suggest me the latest connect edition so that I can download it to update my series 5.
Can I able to download the connect edition without updating the old series 5 so that I can use both .
Hello Hari.
The latest version of StormCAD is 10.01.01.04, which can be downloaded from link mentioned below.
Downloading Haestad / Hydraulics and Hydrology Software
However only one version of the product can be installed at a time on system. You cannot use both SELECT Series 5 & Connect Edition version on the same system.
Sushma Choure
Bentley Technical Suppport
Thank you so much as already Calvin suggest that models are forward compatible. Once again I would like to confirm the model that I created in series 5 will compatible in newer version 10.01.01.04. Right now I am at the middle of my work. Can I download the newer version and complete my rest of the work in new version?
To use InRoad files I am currently using 32 bit.Is there any difference the model created in 32 bit and 64 bit?